EasyStand Bantam Instrukcja Właściciela Pobierz pdf (Strona 25)

Shadow Tray Adjustment

12. To adjust tray depth, loosen each knob as shown all

the way loose. Then ﬂip the red plunger lever in the cen-

ter of each knob fully open. Continue to loosen the knob

until resistance is felt. DO NOT continue to turn the knob

counterclockwise. Forcing the knob past its stop will

damage the mechanism.

The tray may now be removed completely, or adjusted to

the desired position using the click detent positions as a

guide.

13. Release the red plunger levers to re-engage the

locking plungers in the clamp knobs. You may need to

partially tighten the knobs and slightly move the tray

back and forth to allow the locking pins to engage their

“home” positions. Fully close the red plunger levers and

tighten the knobs to secure the tray.

14. To adjust tray angle, loosen one lever clamp

approximately 2 turns at either side of the tray where

the extension tubes are attached, as shown. Support

the tray with one hand before fully loosening the second

lever clamp.

15. Move the tray surface to the desired angle and

re-tighten both lever clamps securely.

Caution: Extra care should be exercised if the tray is

adjusted with a patient seated in the unit to ensure they

are being supported by a chest vest, chest strap or

similar supportive device. Lateral guides by

themselves, even models with an anterior inward curve,

should not be relied upon for frontal support.

Caution: Never adjust or remove the tray while the

patient is standing or in a partially standing position.

12.

13.

14.

15.

Adjustments & Usage

Page 22

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Brak uwag

EasyStand Bantam Instrukcja Właściciela Strona 25